Trailer Parts Pro H84575BX Boxed PreGreasedHub Assembly - 5 on 4.75 - L68149/L44649 Bearings - Fits Most 3500 Lbs Axles - #84 Spindle
Trailer Parts Pro H84575BX Boxed PreGreasedHub Assembly - 5 on 4.75 - L68149/L44649 Bearings - Fits Most 3500 Lbs Axles - #84 Spindle
Attention Customers:
The items we have listed for pop up campers are the only items we have available. We are not able to special order any items at this time, and we are unable to provide technical assistance due to high order volume. Thank you for your understanding.
This is a ready to install Idler H84545BX Boxed Hub Assembly - 5 on 4.75 - L68149/L44649 Bearings - Fits Most 3,500 Lbs Axles with #84 Spindle made by Trailer Parts Pro
Trailer Parts Pro hub kits come with some of your main components like the inner and outer bearings. With Redline kits there is no need to worry about the races as they are already pressed into the hub for you. You will also get the grease seal, grease cap, and wheel nuts for the hub. This hub is designed for use with a #84 spindle. Each Hub has a 1,750lb capacity. Spindle nut and spindle washer sold separately.
The kit comes with labor-saving Pre-Greased and Pre-Installed Bearings, Races, Seal, as well as Standard and Grease-Lube Dust caps and wheel nuts.
Reference#: 107029
Product Specifications
- L68149 Inner / L44649 Outer Bearings
- Capacity of 1,750 lbs. per each
- Fits #84 Spindle
- Std. Grease or E-Z LUBE® Application
- Used on Dexter and most 3,500 lb. axles
- 5 on 4.75” Hub Available in Galvanized finish
Items in Kit
• 1x L68149 Inner Bearing (1.378" ID)
• 1x L44649 Outer Bearing (1.063" ID)
• 1x L44610 Outer Race (Already Pressed In) 1.98" OD
• 1x L68111 Inner Race (Already Pressed In) 2.361" OD
• 1x 10-19 Grease Seal (1.719" x 2.565")
• 1x 46749 Grease Cap (1.986" OD)
• 1x 21-41-1 Grease Cap (1.986" OD)
• 1x 85-1 Grease Cap Plug
• 5x X1023R Coned Wheel Nuts
• 1x 5 on 4.5" Pregreased Hub For Convenience
• 1,750lb Capacity Per Hub
To determine the bolt circle on hubs or wheels with an odd number of bolt holes, measure from outside to center of the studs across the pattern(bolt patterns are always measured in inches). Example: If you were to number the studs 1, 2, 3, then you would measure from the outside of stud 1 to the center of stud 3.
Prop. 65 Warning for California Residents
WARNING: This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.