Ventline by Dexter V2094SP-26 Powered RV Trailer Roof Vent - 12 Volt - 14 Inches x 14 Inches

This radius cornered 12 volt vent includes a replaceable white low profile cover with a white screen frame.

Garnish sold separately.

Ventline Product Brochure PDF

This roof vent uses a 12-volt fan to circulate air in motor homes and enclosed trailers, keeping interiors ventilated without compromising security. Wedge-shaped, white plastic vent cover opens and closes with a hand-operated crank.

Features

• Roof vent's electric fan yields better air circulation than non-powered models, exhausting hot air while trailer or RV remains locked and secure
  • Simple to upgrade from non-powered model
• Basic, hand-operated crank rotates to open and close dome
• Switch to turn the fan on/off is mounted on the vent
• Translucent cover allows some light through
• Aerodynamic, wedge-shaped dome made of durable polypropylene
• Galvanized steel roof flange won't rust or corrode
• Snap-out screen is easy to clean
• Birch White interior trim piece (or garnish) is included
• Made in the USA

Specs

• Included garnish fits roofs 1-7/8" to 3" thick
  • Garnish leg length (depth): 2-1/8"
  • Garnish color: Birch White
  • Other garnish sizes are available (sold separately)
• Fan power: 12-volt DC
  • 100 CFM
• Cover color: white
• Rough opening size: 14-1/4" wide x 14-1/4" long
• Vent extends above roof:
  • 4-1/2" Closed
  • 10" Open
• 2-Year warranty

Notes

• Screws and sealer are not included. See Installation Kit (344270KITW), which includes all necessary screws and sealer to install vent.
• Not for use above tubs, showers or range cooking surfaces.

Installation Instructions

1. Mark desired location for vent. Be sure to choose a location between roof joists.
2. Cut a 14-1/4" x 14-1/4" opening through roof and ceiling. (Or use existing opening if you're replacing a standard 14-1/4" x 14-1/4" vent.)
3. Apply sealant to bottom of flange. Be sure to surround each screw hole.
4. Insert vent through hole with screen frame extending through roof cavity and hinge of vent toward the front of the vehicle.
5. Mount to roof with #8 screws.
6. Remove screen frame and wiring compartment cover to make electrical connections.
7. Connect to 12-volt DC power source
8. Replace screen frame and cover.
9. Attach interior garnish piece with #8 screws.

 

Prop. 65 Warning for California Residents

WARNING: This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.