HWH R1171 Replacement Spring Kit for Hydraulic Leveling Jacks (2 Springs)
HWH R1171 Replacement Spring Kit for Hydraulic Leveling Jacks (2 Springs)
Attention Customers:
The items we have listed for pop up campers are the only items we have available. We are not able to special order any items at this time, and we are unable to provide technical assistance due to high order volume. Thank you for your understanding.
Documents
VideosThis listing is for one R1171 replacement spring kit for HWH Hydraulic Leveling Jacks. Each kit contains two springs.
R1171 Spring Kit Specifications:
- 12-1/4" x 1-5/8" from end of hook to end of hook
- 10-1/16" x 1-5/8" from base of hook to base of hook
- 1.68" diameter
- 57 coils
- Used on 9,000 lb HWH Hydraulic Jacks with 8-1/2" or 14" stroke
Do you need two sets of these springs? Click here to save BIG on a two pack (4 springs)!
NOTE: Counting coils and measuring the diameter of existing springs is only a guide. To make certain you order the correct springs, please find the AP# stamped on your HWH hydraulic jack. Provide this info and we can verify the proper jack springs for your RV.
Which HWH Spring Kit is the right one for replacing the springs on my HWH Hydraulic Jack?
Prop. 65 Warning for California Residents
WARNING: This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
Instruction Sheet for Jack Spring Removal and Replacement
If a vehicle is parked or stored for an extended period of time and the jacks fail to retract completely, extend the jacks back down to the ground then retract the jacks again. If the jacks do not retract completely without assistance, replace the springs. There are two (2) springs included in each spring kit. The correct spring kit must be used.
