Dexter 82113 10 Inch Integral Style Vented Rotor Disc Brake Kit

Tie Down Engineering/Dexter 82113 10 Inch Integral Style Vented Rotor Disc Brake Kit replaces 10 inch Drum Brakes and it mounts to a 4-hole axle brake flange. This kit includes a GALVX finish Vented rotor/hub, 1.98" dust cap,wheel bearings & grease seal, lug nuts, galvanized mounting brackets with stainless steel hardware, aluminum caliper assembly and complete installation instructions. You will need to purchase two of these kits for ONE axle

Product Features and Benefits

• E-Coat finish protects the caliper from salt crystallization.
• Stainless Steel caliper slide pins are easily accessible with 7/16” hex heads for quick removal
• Stainless Steel coated brake pad backing plates further reduce areas susceptible to corrosion
• All aluminum caliper, 380 series alloy, sheds heat five times faster than traditional cast iron calipers
• Compact design allows short axle overhangs and provides direct brake line routing back to the axle
• Oil impregnated bronze bushings last longer and slide smoother
• Oversize rubber boot is 50% thicker by design and provides a more positive piston withdrawal
• Always use High-Temp. Marine Bearing Grease with disc brakes due to the higher operating temperatures as compared to drum brakes.

Product Specs

• Rotor Diameter: 9.6 Inches
• Replaces Drum Diameter: 10 Inches
• Bearing Size: 1-3/8 Inches x 1-1/16 Inches
• Number of Studs: 5
• Bolt Circle: 4-1/2 Inches (13 Inches & Larger Wheels)
• Axle Rating: 3500 lbs.
• Note: Tiedown Disc Brakes are not designed to be used with Electric-Over-Hydraulic Brake Actuators that produce more than 1200 PSI

 

Prop. 65 Warning for California Residents

WARNING: This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.