NBK Parts 20526 Lippert / Schwintek In-Wall Slide-Out Motor – 236575 (IG-42, 10 mm D-Shaft)
NBK Parts 20526 Lippert / Schwintek In-Wall Slide-Out Motor – 236575 (IG-42, 10 mm D-Shaft)
Attention Customers:
The items we have listed for pop up campers are the only items we have available. We are not able to special order any items at this time, and we are unable to provide technical assistance due to high order volume.
For product availability, please text (855) 432-6357 with the vendor number and quantity you are looking for. We will answer ASAP.
NBK Parts 20526 Lippert / Schwintek In-Wall Slide-Out Motor – 236575 (IG-42, 10 mm D-Shaft)
Restore smooth, synchronized travel on Schwintek in-wall slide systems with this direct replacement Lippert 236575 motor (also known as IG-42, 10 mm D-shaft). This drop-in drive replaces worn or weak motors that cause hesitation, racking, or out-of-sync rooms—delivering the correct torque, reduction, and connector so you can bolt up, plug in, resync, and go.
- Direct replacement for Schwintek in-wall slide systems using the 10 mm D-shaft motor.
- Correct gearing & speed for controller expectations ~22 RPM output (no-load) via 300:1 reduction.
- Improved reliability for rooms that stall, chatter, or drift out of sync.
- Plug-and-play lead & connector; no splices or guesswork when used on matching systems.
- Compact IG-42 form factor installs inside the side wall; serviceable without dropping the room.
- (1) Slide-out drive motor, 10 mm D-shaft (Lippert 236575 / IG-42)
- Application: Lippert Schwintek in-wall slide systems
- Output speed: ~22 RPM (no-load)
- Gear ratio: 300:1
- Shaft: 10 mm D-shaft
- Overall size: 6.15" L × 1.65" Ø (approx.)
- Weight: ~2 lb
- Electrical: 12V DC
- Also known as: IG-42 Motor – 10 mm; NBK Parts 20526
- Designed for Lippert Schwintek in-wall mechanisms (vertical aluminum rails with worm-gear tracks).
- 10 mm D-shaft motor used on many single and dual-motor Schwintek rooms; matches controllers expecting ~22 RPM output.
- Not for through-frame (rack & pinion) slides, hydraulic slides, or Power Gear rack systems.
- Look for Schwintek side rails at the room edges (vertical extrusions with slots).
- Verify your old motor has a 10 mm D-shaft and matches the IG-42 form factor.
- If your system uses a different shaft style or an external gearbox, contact us before ordering.
- Support the room; disconnect 12V power before service.
- Swap one motor at a time and ensure the D-shaft fully seats in the coupler.
- After replacement, perform a controller re-sync (extend fully, hold switch; retract fully, hold) per Lippert procedure so both sides time correctly.
- Inspect rails for debris and lubricate per Lippert’s non-petroleum guidance.
Prop. 65 Warning for California Residents
WARNING: This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.