Dexter 8-285-10 Oil Bath Hub and Drum Only - 4.75 Inch Pilot - Fits Dexter 8000 Lbs Axles - 9/16 Inch Studs
Dexter 8-285-10 Oil Bath Hub and Drum Only - 4.75 Inch Pilot - Fits Dexter 8000 Lbs Axles - 9/16 Inch Studs
Attention Customers:
The items we have listed for pop up campers are the only items we have available. We are not able to special order any items at this time, and we are unable to provide technical assistance due to high order volume. Thank you for your understanding.
Dexter 8K Oil Hub & Drum Only with 5/8in Studs
Dexter 12-1/4" x 3-3/8" Hub & Drum W/ 8 on 6.5" Bolt Pattern 8,000lb Axles
Dexter hub & drum only. There is no need to worry about the races as they are already pressed into the hub for you. The bearings, oil seal, grease cap, and wheel nuts for the hub are sold separately. This hub is designed for use with a #42 spindle. Each hub & drum has a capacity of 4,000lbs. Spindle nut and spindle washer sold separately.
Items Included
• 1 02420 Outer Race (Already Pressed In) 2.688" OD
• 1 8 on 6.5" Hub & Drum
• 4,000lb Capacity Per Hub
• Use with a 12-1/4" x 3-3/8" brake
Items Sold Separately
• 1 02475 Outer Bearing (1.25" ID)
• 1 10-63 Oil Seal (2.25" x 3.376")
• 1 21-35 Oil Cap (2.72" OD)
• 1 46-32 Oil Cap Plug
• 8 95188 Flanged 5/8" Wheel Nuts
To determine the bolt circle on hubs or wheels with an even number of studs, measure center-to-center of studs directly across from each other on the diameter(bolt patterns are always measured in inches). Example: 8 on 6 1/2 would mean 8 studs with 6 1/2” center-to-center diameter.
Prop. 65 Warning for California Residents
WARNING: This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
Determining the Bolt Pattern
The first number in the bolt pattern is the number of bolt holes. The second number denotes the diameter, in inches, of the circle on which the bolt holes sit.
On wheels with an even number of bolt holes, measure from the center of one bolt hole to the center of the hole directly across from it. (Example: 8 on 6-1/2 means 8 bolt holes with 6-1/2" from the center of one hole to the center of another on the opposite side.)
To determine the bolt-circle diameter on wheels with an odd number of bolt holes, measure from the center of any bolt hole to the point halfway between the two bolt holes directly across from the first. (Example: 5 on 4-1/2 means 5 bolt holes with 4-1/2" measured to a point halfway between the opposite bolt holes.)
Measuring the distance (D) from the center of one bolt hole on the wheel to the center of a bolt hole right next to it can also help to determine the bolt pattern.
- If D = 2-5/8", then the bolt pattern is 5 on 4-1/2"
- If D = 2-3/4", then the bolt pattern is 5 on 4-3/4"
- If D = 3", then the bolt pattern is 5 on 5"
- If D = 3-1/4", then the bolt pattern is 5 on 5-1/2"
