Tie Down Engineering 11253 Back Flow Disc Brake Reversing Solenoid
Tie Down Engineering 11253 Back Flow Disc Brake Reversing Solenoid
Attention Customers:
The items we have listed for pop up campers are the only items we have available. We are not able to special order any items at this time, and we are unable to provide technical assistance due to high order volume. Thank you for your understanding.
Unlike drum brakes, disc brakes generate full braking power in reverse. A reverse lockout solenoid should be installed at the actuator before installation of disc brakes. The Backflow design allows for changing to reverse while vehicle is stopped in a down hill position. The 12 volt solenoid valve connects to the tow vehicles back up light circuit for automatic brake lockout. Unit can be wired independently or adapted to trailer wire harness with a 5-flat plug on trailer and tow vehicle.
Thread Size:
- 3/16 Inch IF x 1/8 Inch MP
NOTE: Adapts to hydraulic actuators with provisions for inlet tubes

Prop. 65 Warning for California Residents
WARNING: This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.